surfboard deck grip, deck grips, surfboard tail pads, tail pad, surfboard traction pad Australia

Sticky Johnson surfboard grip - NZ's premiere surfboard tail pad uses premium quality EVA foam and 3M adhesive. Super grippy diamond square cut means unreal traction.

Once you try 'em you’ll be stuck on 'em.....get on board!

• super thin 1.5mm pad base to maximise board sensitivity under foot
• 3M adhesive backing surfboard grip
• 27mm kick tail for maximum performance
• 5mm deluxe arch bar
• sloped tail kick
• diamond square cut for super grip
• premium quality EVA foam 
• 2 piece or 3 piece options

 Styles

SLIT 3 piece colourways in order top left to bottom right: blue black, green black, grey black, marble black, marble blue black, black, black blue, black green, black grey

BILBO - Curve rider Billy Stairmands signature pad! 3 piece colourways in order top left to bottom right: black, grey black, olive black, black olive

STICKY STAR 3 piece colourways in order left to right: blue, green, orange, grey

 ILLUMINATOR 3 piece colorways in order left to right: orange, blue

BIG BOI SABRE 3 PIECE made wider for modern wide tail shortboards. 

JAWS 3 piece colourways left to right black, white, blue

Protect your board and increase traction by applying deck grip as follows

• Make sure your board is 100% clean and dry from any wax, debris or moisture. Hint: use a Curve Power Wax Scraper to easily remove the bulk of your wax. Remove all remaining wax residue with an old rag, or rub in some fiberglass dust (ask your local shaper) or even better Sticky Johnson Wax Remover
• Position rear edge of surfboard grip over back base of your rear fin – getting close to but not overlapping leash plug. For wider boards you may want to spread the grip side bars out (taking care not to overlap rails) and for narrower boards leave as a solid pad.
• Pencil an outline of desired traction pad position.
• Line up centre surfboard grip with centre surfboard stringer and apply slowly from bottom up, avoiding air bubbles.
• Line up surf grip side bars equally and apply. Leave the traction pad for at least 12 hours to fully dry.
• Your new grip is ready to rip!